I had hoped to have some more photos ready for this post, but they’re on my camera and that’s in the car, 20 minutes away. Maybe next time.

Anyway, I have very nearly completed the first half of the layout. The right-hand side has all but two pieces of track laid, and all but one set of track feeders in place. I’ve begun laying the matching track pieces on the left hand side, and this is basically where I’m holding myself up. 4 pieces of track cross the line between the two sides, and of these 2 are done and dusted. The third needs me to lay a curved piece of flex track across the line, and this is where I lose excitement. I want to do this section first, because the fourth and final section to cross the line is the one that actually has a useful purpose on the left hand side, rather than just being sidings to store cars for businesses that the model will ‘serve.’

I divided the whole layout into several sections. I doubt I’ll ever operate it with more than one person, but in theory it could be operated with two engines, and with the split sections that becomes a little easier with basic DC power (since I’m underfunded for DCC right now..). For now I’m tying all of the feeders for the sections to each other and then I’ll link those to a single pair of wires to the controller until I make a real control panel with switches etc. I also need to find some 3-way wire to wire the turnout motors, but again that can wait. My goal is to be able to drive on at least part of it by the end of the week.

In other news, I’m fast running out of solder, so I may need to hunt down some more..